Parts

Hope Pad Clip • Fits Tech and Tech Evo M4, X2, and V2 Brakes

- Non-SIS 5mm alloy ferrules - Sold individually - Color: Silver

Replacement reservoir cap screw for Hope brakes.

Replacement bearing for the lower half of YST8003 #7 headset.

Replace the top bearing in your YST8300 headset with these caged ball bearings.

Sunlite's Cable End Button replaces the worn out piece that goes between your brake cable and the brake lever body. Replacing it along with cables and housing helps add new life to your brakes and shines u the bike, too!

RaceFace X-Type Bottom Bracket Outer Race Seal - Replacement for cracked or broken X-Type outer race seals - Sold each

- Aheadset preload adjusting bolt

M7 Shaft/M6 Head 48mm Long

- w/Nut - 1-3/4-inch

- 8x1mm Allen head

- Model: Replacement bolt - Compatibility: Allen, M5x16

Interlok spacers nest into the lip of Cane Creek headset uppers for a rock solid, flex-free fit. - Composite construction

This is a replacement Brake Hose Cover for the Lever End of Shimano BH90-SBM, BH90-SB levers. - Covers brake hose fitting at the brake lever

Shim spacers can be placed between bearing and compression cover in IS headsets to fine tune the fitment.

- Aluminum w/lock nut - 18mm long/6mm O.D.

- Replacement cable anchor bolt for brakes - Includes nut and washer

- Aluminum w/lock nut and mount - Slotted mount design

- Crank dust cap - Works with most three-piece crank models

- Chrome - Sold individually

- M8 Top Plate Bolt

KMC 3/16" Master Link Chain Links - For 3/16" chain, extra wide - Extra-wide, for non-derailleur bikes: BMX, cruisers, etc - Perfectly fits on KMC 415H & 415H-NP chains

- Half-link connector allows you to add or subtract half of one link (1/2 inch) from the chain in order to optimize chain tension - Uses standard chain pin connector and tool

- Model: Derailleur Bolt & Nut - Compatibility: Mounts rear bracket to frame

- For MTB levers - 7mm x 1mm - Aluminum construction

- Routes cables underneath the bottom bracket - Will not rust or corrode

Hope Disc Brake Hose Small Parts · This washer fits on both sides of the banjo bolt and seals the hose fitting into the master cylinder

- Allows quick chain removal without tools - MissingLink 410HD|~|1sp|~|BMX Heavy Duty chain|~|9.4mm|~|each|~| - MissingLink 410|~|1sp|~|BMX|~|8.6mm|~|each|~| - MissingLink II|~|8sp|~|all|~|7.1mm|~|6/card|~| - MissingLink-9|~|9sp|~|all|~|6.6mm|~|6/card|~| - MissingLink-10R|~|10sp|~|KMC, Shimano, SRAM|~|5.9mm|~|6/card|~| - MissingLink-10CR|~|10sp|~|Campagnolo only|~|5.9mm|~|6/card|~| - MissingLink-11|~|11sp|~|Campy, KMC, Shimano|~|5.5mm|~|6/card|~|

Stainless steel pedal washers - Sold in pairs

- Size: 1/2x1/8 & 3/32 (set) - Links: 1 each per bag